![]() Multiple Subnet ACL The maximum number of ACL entries that can be configured on the Easy VPN client is 20. In order to avoid the network conflicts on the OpenVPN server there are not the routing rule for the remote sites, there is a specific lookup routing table for each PC like that: # ip rule shġ0: from all to 10.10.10.0/24 lookup mainĪnd under each # ip route show table 1024ġ92.168.80.0/24 via 10.10.10. Multicast and static Network Address Translation (NAT) are supported only for Easy VPN remote using dynamic virtual tunnel interfaces (DVTIs). The configuration can act in Network extension or Client mode. ![]() The remote site does NOT need to have a statically assigned IP address on its external interface. ![]() EasyVPN can be used to create IPSec VPN tunnels between a ‘headend’ and ‘remote’ location. This setup works perfectly while using TAP device. Here are the main points that I came out with. We will also look at how to support multiple remote subnets, and NAT compatibility specifically when you run Network Extension or Network Extension Plus. The PC1 connect to RemoteSite1 and the PC2 connect to RemoteSite2 but while using iroute one of the PCs reach the wrong remote site. My concern is, that their local network 192.168.1. I have some issue with an OpenVPN concentrator while using TUN device. I know this software is unsupported for quite some time already, but still works fine and is the only option at this moment.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |